Jump to content
  • Join the TowForce community.

    It looks like you're not logged in. Register to get started and to receive Tower Down Notices.

After-Market L.E.D. Tailights for Jerr-Dan med./heavy beds


Recommended Posts

We have an After-Market Taillight housing available for the Jerr-Dan Medium-Duty (14-16 ton) & the heavy-duty (25 ton on up) beds.




This picture shows the brushed stainless mounted in a 25 ton body. The reverse lights were moved to the lower worklights. We have also used the Hybrid Maxxima light which has the reverse light in the ring of the light.




Here is a picture of the polished stainless housings mounted in a 14/16 ton body. The reverse lights were installed in the lower worklights, & in a pair of worklights mounted by the hydraulic spades. once a gain you could also use the hybrid Maxxima light with the reverse light in the outer ring to meet D.O.T. compliance.




A little wiring ability is required for install, you need to cut the old ends off & install new ends for the L.E.D. lights. We have options for L.E.D. lighting (the cut-outs are standard sizes). You may need to replace the hardware (screw tabs) in the body. The housings come with rubber trim, & 4 new stainless screws per housing. The housings are sold in pairs, & come in brushed or polished Stainless. Give my parts guy Eric a call with any questions. 800-282-2793



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...
Please Sign In or Sign Up